Robotronics Buzz E Instrucciones de operaciones descargar pdf (Pagina 26)

Cassette Tape Player

CHAPTER 4 Cassette Tape System

The cassette tape system is located inside the robot on the metal electronics box. The system

is activated by remote control from the remote control box. (Additional instructions are on the

next page.)

How to Play A Cassette Tape

1. Insert a regular type cassette tape into the player.

2. Depress the play button on the cassette player.

3. Move the radio tape select switch to the tape position.

4. Activate the tape from the control box.

5. Adjust the volume to desired level.

The tape head of the cassette player should be cleaned after every 25 to 30 hours of use.

Always remove the cassette tape when not in use. This will prevent flat spots on the capstan

roller.

Troubleshooting - Cassette Player

Problem/Cause Action

Cassette Player

No tape operation

1. Tape player not on tape mode or volume not turned up.

1. Put mode select to tape and turn volume up.

2. Play button not pushed 2. Must push play button before hitting the switch on the radio

control.

3. Bad Tape. 3. Check tape in other tape player.

4. Tape is too tight. 4. Loosen with a pencil by spinning tape.

5. Player is not getting power because power wire or plug is

broken.

5. Check for 3 Volts at power plug. Replace plug or repair the

wire.

6. Power or audio wire has come disconnected from the main

board.

6. Open the main box and re-connect to board.

7. Radio control or tape circuit not working 7. Contact Robotronics for help.

No siren, or voice either.

1. Audio fuse blown.

1. Replace the fuse. See fuse block diagram.

Poor quality sound or slow.

1. Belts worn out and slipping.

1. Replace cassette player or belts.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 60 61

Sin comentarios

Robotronics Buzz E Instrucciones de operaciones Pagina 26